VMS IP Commands For TCP/IP Services

As the system administrator (“SYSTEM”), one can use and maintain TCP/IP services in various ways. The below are all CLI commands, with DCL. (Note: Exclamation marks, i.e. “!”, denote comments.) relating to VMS IP Commands. To display the current configuration, the most rapid way would be by invoking the following command: $ SHOW NETWORK With […]

Read More…

Unix IP Commands For TCP/IP Services

The following are some of the more used command lines relating to Unix IP Commands. Description Unix IP Command Display Current Config for all NIC’s ifconfig Display Current Config for dc0 ifconfig dc0 Assign multiple IP’s ifconfig dc0:0 192.168.1.2 Assign second IP ifconfig dc0:1 192.168.1.3 Disable network card ifconfig dc0 down Enable network card ifconfig […]

Read More…

Linux IP Commands for TCP/IP Services

The following are some of the more used command lines relating to Linux IP Commands. Description Linux Internet Protocol Command Display Current Config for all NIC’s ifconfig Display Current Config for eth0 ifconfig eth0 Assign IP ifconfig eth0 192.168.1.2 Ping ping -c 3 192.168.1.1 Assign multiple IP’s ifconfig eth0:0 192.168.1.2 Assign second IP ifconfig eth0:1 […]

Read More…

IP Commands for DOS/Windows

Firstly, DOS/Windows IP commands are used to perform several tasks like assigning an address to a network interface or configuring network interface parameters.  To clarify, below is only a small list of these type of commands that are available. Moreover, below you’ll find a list of the most common Internet Protocol commands for Windows and […]

Read More…